Comark RF500A Uživatelský manuál stáhnout pdf (Strana 12)

The Gateway contains an internal backup battery, if this battery is not sufciently charged; the

Gateway will not switch on. Once external power is connected the internal battery will begin

recharging. Whenever the charge state becomes sufcient the Gateway will automatically start as requested.

Whilst in this mode Status LEDs 1, 2, 3 and 4 will ash in sequence. See “Figure 8 – Left Hand Side View of

Gateway” {Page 26} for location of these LEDs.

It takes a few minutes for the Gateway to initialise; a sequence of 2 beeps followed by 4 beeps indicates

successful initialisation.

Gateway Switch OFF

To turn the Gateway OFF navigate to the hardware page of the Gateway Web-View and use the Shutdown Gateway

button, this will initiate the Gateway shut-down procedure.

If for some reason it is not possible to use the Gateway Web-View, then using a paper clip or similar object, press in

and hold the ON / OFF switch on the side of the Gateway for 4 seconds. The Gateway will beep once and the ON

indicator will ash at a 3 second interval to indicate shut-down. Once the shut-down sequence begins, the Gateway

will beep 10 times in quick succession. The shut-down procedure could take up to 5 minutes to complete. After

shut-down is complete the ON indicator extinguishes.

Gateway Reset

There are several circumstances under which the Gateway will perform a software reset, (for example performing

Gateway Clock Setup). At start of the sequence the Gateway will beep 10 times in quick succession. The reset

could take up to 5 minutes to complete which is indicated by a sequence of 2 beeps followed by 4 beeps to indicate

successful initialisation. Unlike the shut-down described above, the ON indicator will remain steady during the reset

sequence.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 65 66

Žádné komentáře

Comark RF500A Uživatelský manuál Strana 12